Philips VHS VR6393 - Manual (Page 11)

— If a protected cassette is loaded when you are trying to
make a recording, the Display shows for 5 seconds:
l I M I
LOOnr.
.1 I ^ U I
/ I I I I V '>
Ega
The cassette will be ejected.
— If the end of the tape is reached during recording, the
cassette will be ejected automatically and the video recorder
will switch itself to standby. __________
©To interrupt the recording, press ■ once.
• To resume recording, press • (A with •) again within 8
minutes.
This ensures a smooth join (auto-assembling).
Note:
If • (A with •) is not pressed within 8 minutes, the video
recorder automatically switches to stop. After another 8
minutes without tape movement, the video recorder
automatically switches to standby.
® To stop the recording, press ■ twice.
To eject the cassette, press A.
PLAYING A CASSETTE
7
© Switch on the TV.
@ On the TV select the preselection number for the video
recorder.
® Load a pre-recorded cassette.
The Display shows, for example:
c Tnn
D
01
-1 1 Ul
P iU
n
sni ■ u
Note:
If you load a cassette which has the erase tab removed, the
video recorder wili start piaying the cassette automaticaiiy. You
may then omit step 0.
© Press ►.
On your TV you will see the recording.
The Display shows, for example:
© Press ■ once to interrupt playback.
nni ll~l~
1 1 iu_u_ P
in
lU
Esa ■
1 . 1C
• Press ■ twice to stop playback.
© Press A to eject the cassette.
The Display shows, for example:
i~OCC
Ul l_l_l
p E
r inn
C ILJLJ
Note:
When the tape reaches the end during playback it automatically
rewinds to the start.
Correcting picture disturbances (auto-tracking):
• Press ►.
• Press (®).
The video recorder will automatically find the best playback
quality within a few seconds.
The sound is muted.
With very poor recordings the video recorder may not
automatically find an optimum.
• Press ►.
• Press Si.
• Then press ► when you see an acceptable playback quality.
Searching with picture for a tape position:
• Press ►.
• Press E) or ®.
The tape will (re)wind at 7 times the normal speed with picture
but without sound.
Note:
The picture may be affected by interference as it (re)winds
quickly.
This does not indicate a malfunction.
• Press ► again when the required tape position is reached.
Searching without picture for a tape position:
• Press ■.
• Press ►► or -4^.
The tape will (re)wind at high speed without picture or sound.
• Press ► when the required tape position is reached.
Entering the tape position you want to go to (GOTO)
• If necessary, press (1^) one or more times to display the used
time, the time left or the tape counter position.
• Press (•♦*♦■).
• Press (0-9) to enter the tape position (hours and minutes in
case of used time or time left) you want to go to.
• Select the function to be started from that point, for example
playK record • (A with •), stop ■ or standby lO-
The tape will (re)wind to the entered tape position and start the
chosen function from that point.
Still picture:
• Press ►.
• Press
II.
Each time you press this button, the tape advances several
frames.
Note:
The video recorder will automatically switch to playback after 8
minutes of still picture to avoid tape wear.
if you notice a vertical vibration in stiii pictures:
Ь) 7