Alarm on/off, Switching off the alarm, V 3 u – Philips AJ3720 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ALARM on/off
SWITCHING OFF THE ALARM
There are two ways to switch off the alarm. Unless you cancel the
alarm completely, the ALARM RESET will be automatically
selected after 60 minutes, from the time your alarm first sounds.
Note: During an alarm call or repeat alarm, only the ALARM
RESET/RADIO OFF and REPEAT ALARMA
ime
date
controls on the set will operate.
Alarm reset
If you want the alarm mode to be stopped immediately but also
wish to retain the same alarm setting for the following day:
1. Press ALARM RESET/RADIO OFF.
You will hear a long beep tone confirm that the ALARM
RESET has been activated.
Repeat alarm
This will repeat your alarm call at approximately 9 minute
intervals.
1. During the alarm call, press REPEAT ALARM/
timedate
.
After 9 minutes the alarm will call again.
2. You can press REPEAT ALARM/
time
date
again as often as
desired.
-■The alarm mode indication J] or in the display will
flash throughout the time when REPEAT ALARM/
timedate
is active.
jj
:
I
n
u
1.3 n
V 3 U
10