Philips AJ3720 - Manual (Page 4)

CONTROLS INSTALLATION
m
3
CQ
TOP, FRONT and SIDE PANEL
© REPEAT ALARM/riME DATE:
- To switch off the alarm for a 9 minute
period.
- To display/adjust the date (month and day)
and the year
- To resume clock time display
® DISPLAY: To show the status of the set
® PRESET 1-5:
- To select a preset radio station
- To select a preset radio alarm
® ALARM RESET/RADIO OFF:
- To stop the active alarm for 24 hours
- To switch off alarm 1 or 2 completely
- To switch off the radio
© SLUMBER/BUZZER
- To adjust the slumber time on/off
- To select the buzzer mode for alarm 1 or 2
® RADIO ON
- To switch on the radio
- To go to radio display for 10 seconds
- To select the radio mode for alarm 1 or 2
© BAND: To select the waveband
(D
(D
ÖQ)
ALARM l:To set, review or switch off alarm 1
ALARM 2: To set, review or switch off alarm 2
VOLUME: To adjust the radio sound level
TUNING / or ►>! (up or down)
To tune to radio stations automatically or
manually
To adjust the clock time, alarm time, date,
yearand time zone settings
0:3.5 mm headphone socket
WEEKEND SLEEPERA imezone :
To activate or deactivate the weekend
sleeper for alarm 1 or 2
To select the time zone
SET:
To confirm preset stations stored
To activate the setting mode for clock time
BRIGHTNESS CONTROL To change the
brightness of the display illumination
Pigtail: For FM reception
MAINS: for connecting the set to the mains
supply
MAINS CONNECTION
1. Check if the mains voltage as shown on the type plate (on the
bottom of the set) corresponds to your local mains voltage. If
it does not, consult your dealer or service organisation.
If your set is equipped with a voltage selector, found on the
bottom right-hand corner of the set, adjust the selector to
correspond with your local mains.
2. Connect the mains plug to the wall socket.
- The mains supply is now switched on and the numbers on
the display will start to flash. You will need to set the
correct time.
3. To switch off the mains supply completely, pull the mains plug
out of the wall socket.