Philips MAS-300 - Manual (Page 13)

Basic Functions
iwwr-w tic : I'/in
i/L 1 M-/
("1 l\ 1 “
U f «/
« . sa altS? is aa aa _
tma wimi w
aacDl
I csd I
CE)CED C3
CHDBCE)
IMPORTANT]
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
First time setup/power up
When you turn on the main power "HL/TD
lUSPOLL -Pf?C5S PLfiy" is displayed.
Press ►!! on the system to start installation.
’IfjyrRLL" is displayed,.followed by'fUfCR"
and “RUfD‘.
"+ PROO starts flashing.
"♦ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To reinstall Plug and Play
In Standby or Demonstration mode, press and
holdPII on the system until "RLlfO IN5TRLL
- PRE55 PLR‘J" is displayed.
Press ►11 again to start installation.
^ All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
• Press ■ on the system.
-b If you do not complete the Plug and Play
installation, the function will be restarted when
you next turn on the main power again.
Notes;
- When the power is turned on, the disc tray may
open and close to initialize the system.
- If no stereo frequency is detected during
Plug and Play, "CHECK RNfCNfJR" will be
displayed.
- During Plug and Play, if no button is pressed
within IS seconds, the system will exit Plug and
Play mode.
13