Loading tape, Playing tapes, Continuous playback of two tapes – Philips MAS-300 User Manual
Page 21: To interrupt playback, To stop playback, Tape operation / recording, I r p e, Gib), Ckked chd¡ c5dced, Tape
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tape Operation / Recording
Q
“ I R P E
W'Mil Wt
1 rWNEK
n
acoomceinAv HBBIHE
1*. c
\ \
FUU AfJTO STOP
gIB)
•» ) I ►> l№m(i(
jij
«mm.
MW OMsmiiin sw -------------------------
—
4
1
DECK 1 SMwatHceoho
\
fwseKM DECK 2
CKKED CHD¡
C5DCED®
SSS.
IMPORTANT!
-
Before
playing a
tape, check
and tighten
slack tape with a pencil. Slack tape may
jam or burst In
the mechanism.
-
C-120 tape Is extremely thin and Is easily
deformed or damaged. It Is
not
recommended for use In this system.
- Store the tapes at room temperature and
do
hot f>ut
them too close to a magnetic
field (for example, a
transformer, TV or
speaker).
Loading tape
Press
TAPE
to select TAPE
mode,
"TRPE" is displayed.
Press ait to open the tape
deck door
2
3
4
Close the tape deck door.
Load the tape with the open
side downward and full spool to the left.
Playing tapes
To playback a selected tape deck
•
Press ► on tape deck 1 or 2,
^ The tape will stop at the end of playback.
Continuous playback of two tapes
1
Load the tapes in tape deck 1 and 2.
2
Press
►
on tape deck 2.
3
Press
II
on tape deck
1
, followed by
►
.
^ Playback will begin from tape deck 2 and
continue with tape deck 1. It will stop at the end
of tape deckl
To Interrupt playback
•
Press II
•
To resume playback, press
II
again.
To stop playback
•
Press Hбl:.
21