Philips MAS-300 - Manual (Page 19)

Radio Reception
T'iriER
A..... ~~
If
ttirtfl njWHI UKIsl
CD W
ODq
a®©
iWfpul ws
(VlfST) pST)
Tuning to radio stations
1
Press TUNER to select TUNER mode.
^ "fUNCf?” is displayed. A few seconds laten the
current radio frequency will appear on the
display
^ If an FM station is received in stereo, co ¡s
displayed.
2
Press TUNER again to select the desired
waveband ; FM or AM.
3
Press and hold « or ►► until the frequency
indication starts to change, then release.
The display will show "ijERRDT until a radio
station with sufficient signal strength is found.
4
Repeat step 3 if necessary until you find the
desired radio station.
• To tune to a weak station, press or ►► briefly
and repeatedly until optimal reception is found.
Storing preset radio stations
You can store up to 40 preset radio stations in
the memory. * •
Automatic Preset Programming
• Plug and Play setting (refer to "Basic Functions -
Plug and Pla/’).
OR
1
Press TUNER to select TUNER mode.
1b begin automatic preset from a desired
preset number
• Press M or N to select the desired preset
number.
If a radio station has been stored in one of
the presets, it will not be stored again under
another preset number
2
Press and hold PROGRAM until ”RUTD” is
displayed.
PROG starts flashing.
-♦ All available radio stations with sufficient signal
strength will be stored automatically, starting
from FM and followed by AM band.
-♦ When all the available radio stations are
stored or the memory for 40 presets are used,
the last preset radio station will be played.
To stop storing the automatic preset
• Press PROGRAM or ■ on the system.
Note
— If no preset number Is selected, automatic preset
will begin from preset (1) and all your former
presets will be overridden.
19