Canon IMAGERUNNER 2020 - Manual (Page 136)

Specifying Common Settings 5-20
Customizing Settings
5
3
Press [ ] or [ ] to select <ENTRY TONE>, <ERROR
TONE>, <TX JOB DONE TONE>, <RX JOB DONE TONE>,
<SCAN DONE TONE>, or <PRINT DONE TONE>
➞ press [OK].
4
Press [ ] or [ ] to select <ON>, <ERROR ONLY>, or
<OFF> for the tone you are setting
➞ press [OK].
If you selected <OFF>, proceed to step 6.
5
Press [ ] or [ ] to select the volume for each tone
➞
press [OK].
You can select from 1 to 3.
Repeat steps 3 to 5 to set the volume for other tones.
The selected tone is set.
6
Press [Stop] to return to the Standby display.
OK
AUDIBLE TONES
1.ENTRY TONE
ENTRY TONE
ON
OK
ENTRY TONE
ON
ENTRY TONE
1
OK
ENTRY TONE
1
AUDIBLE TONES
2.ERROR TONE
Stop