Canon IMAGERUNNER 2020 - Manual (Page 96)

Finisher-U1 4-12
Op
ti
ona
l Eq
uipm
ent
4
Finishing Modes
The Finisher-U1 is equipped with the following finishing modes.
CAUTION
• Do not place anything other than output paper in the trays of the finisher, as this
may damage the trays.
• Do not place anything under the trays of the finisher, as this may damage the
trays.
NOTE
If the Collate or Group mode is set, the output tray moves downward as the stack of
paper that is output increases in quantity and thickness. Once the output tray has
reached its stacking limit, printing stops temporarily. Remove all of the prints from the
output tray, and printing resumes.
■ Collate Mode
The prints are automatically collated into sets arranged in page order.
■ Group Mode
All prints of the same original page are grouped together.
■ Offset Mode
The print output is shifted alternately to the front and back of the tray, in a vertical (portrait)
orientation, or a horizontal (landscape) orientation, depending on the orientation of your
originals. For example, if you place LTRR originals, the paper is output and shifted in the
horizontal direction. If you place LTR originals, the paper is output and shifted in the
vertical direction.
IMPORTANT
You can offset 11" × 17", LGL, LTR, or LTRR paper.