Jaypro Sports BBFP-30 - Manual (Page 11)

Rev-A Page 11 of 13
Foul Pole Assembly:
1. Install the “safety stop bolt” hardware into the third hole from the top (see
figure 9). This will allow the top pole to rest inside the lower foul pole
during assembly.
2. Install the yellow powder coated cap on top of foul pole with #12-14 self-
drilling screw (figure 10).
3. Drill two holes using the pre-drill hole as a guide in the lower foul pole.
Note drill holes for 1/2” hardware.
4. Assembly the top and lower foul poles with 1/2" hardware as shown on
figure 11.
5. Using a lifting device (crane) insert the assembled foul pole into the
ground sleeve. Rotate the post so that the panels are to the inside of the
field (figure 1). Drill a hole thru the post using the hole in the ground
sleeve as a guide (figure 12).
6. Install the 1/2” thread rod and flange nuts (figure 12).
7. After assembly is complete, fill gaps around the joints between the top and
lower pole with polyurethane or silicone caulk / sealant.
8. Spray / paint expose hardware if desired.
FIGURE: 9