Casio WK1800 - Manual (Page 61)

E-59
Setting Screens
Pitch Bend Range (Initial Default: 02)
This setting specifies the change in pitch caused when the pitch bender
is at its maximum position. You can set a value in the range of 00 (no
change) to 12 (12 semitones).
Assignable Jack Function (Initial Default: SUS)
This setting specifies the function of the foot pedal as: sustain, soste-
nuto, soft, or rhythm pedal.
Sustain Pedal (SUS)
Applies a sustain effect*
1 when the pedal is pressed.
Sostenuto Pedal (SoS)
Applies a sostenuto effect*
2 when the pedal is pressed.
Soft Pedal (SFt)
Softens notes played while pedal is depressed.
Rhythm Pedal (rHy)
Pedal performs same operations as the START/STOP button.
*1 Sustain Effect
With piano tones and other sounds that decay, the pedal acts as a
damper pedal, with sounds being sustained longer when the pedal
is depressed. With organ tones and other continuous sounds, notes
played on the keyboard continue to sound until the pedal is re-
leased. In either case, the sustain effect is also applied to any notes
that are played while the pedal is depressed.
*2 Sostenuto Effect
This effect performs the same way as sustain, except that it is ap-
plied only to notes that are sounding already when the pedal is
depressed. It does not affect notes that are played after the pedal
is depressed.
Sound Range Shift (Initial Default: oFF)
This setting shifts the range of a specific tone one octave up or down.
This makes it possible to shift the piccolo tone range so you can play
it within the keyboard range. You can also shift bass and other low-
range tones so they can be played within the keyboard range.
Sound Range Shift Off
• Sound within range specified by General MIDI.
Sound Range Shift On
733A-E-061A
1 octave up
072 Piccolo
1 octave down
032 Acoustic Bass
033 Fingered Bass
034 Picked Bass
035 Fretless Bass
036 Slap Bass 1
037 Slap Bass 2
038 Synth Bass 1
039 Synth Bass 2
043 Contrabass
WK-1800/1600(E)-58~59 03.7.31, 5:22 PM Page 59 Adobe PageMaker 6.5J/PPC