Connect Tech BLUE HEAT/NET SYNC CTIM-00044 - Manual (Page 15)

Connect Tech Blue Heat/Net Sync User Manual
Revision 0.03 15
Connecting Power
The Blue Heat/Net Sync uses either a standard DC power jack or a Phoenix locking screw
terminal connector for power input. The Blue Heat/Net Sync can be safely connected or
disconnected at any time. The standard power supply requirements are as follows:
Model BMG006
5V (2.5A) power input using a DC barrel or Phoenix screw terminal connector. Rev A
models.
5V (2.5A) – 28 V DC (450mA) power input using a DC barrel or Phoenix screw terminal
connector. Rev B or greater models only.
DC Power Connector
Figure 9: DC Power Connector Illustration
NOTE: The center is positive, outside is ground (0V).
Phoenix Locking Screw Terminal Connector
Figure 10: Phoenix Locking Screw Terminal Power Connector Illustration