Connect Tech BLUE HEAT/NET SYNC CTIM-00044 - Manual (Page 45)

Connect Tech Blue Heat/Net Sync User Manual
Revision 0.03 45
Configure Default Blue Heat/Net Sync
You can choose this option when your Blue Heat/Net Sync still has a factory default IP address
of 192.168.42.1. It will launch the Web Configuration Manager for this IP address, enabling
you to configure your Blue Heat/Net Sync as outlined in the
Web Configuration Manager .
Figure 27: Add or Auto Discover Blue Heat/Net Sync Menu Screen
Add New Blue Heat/Net Sync
You can add a Blue Heat/Net Sync by specifying its IP address or MAC address.
If you specify an IP address, the Configuration Manager will connect to that specific Blue
Heat/Net Sync and the configuration information for installation. If it cannot connect, it will not
install the unit. The Blue Heat/Net Sync may get the IP address from DHCP server or it can be
manually fixed. The Configuration Manager will use 49152 as the default TCP port. This value
is configurable.
If you specify a MAC address (located on the underside of the device), the Configuration
Manager will use the auto-discover mechanism to retrieve the information for installation. The
auto-discover mechanism uses UDP broadcast, so the unit must be located on the local network
to install via MAC address. The Configuration Manager will use 49152 as the default UDP port.
This value is configurable.
Figure 28: Add Blue Heat/Net Sync Screen