Connect Tech BLUE HEAT/NET SYNC CTIM-00044 - Manual (Page 60)

Connect Tech Blue Heat/Net Sync User Manual
60 Revision 0.03
Serial Mode (smode)
BHN_PortSettings
Async MonoSync BiSync Trans-BiSync HDLC
sync_addr.rx0 Required Required Required Required
sync_addr.rx1 Required Required Optional
sync_addr.rx_len Required Required Required
sync_addr.strip_sync Optional Optional Optional
dbits.t/rx Required Required Required Required Required
tx_frac_stop Required
parity.t/rx Required
crc.tx_type Required Required Required Required
crc.tx_start Optional [6] Optional [6] Optional [6] Optional [6]
crc.tx_mode Optional [6] Optional [6] Optional [6] Optional [6]
crc.rx_type Optional [6] Optional [6] Optional [6] Optional [6]
crc.tx_start Optional [6] Optional [6] Optional [6] Optional [6]
tx_trig_gate Required Required
rx_gate Required Required
Required [1]:
Must be NRZ or NRZ_INV
Optional [1]:
Needed if a clocking source feeds either of the Baud Rate Generators. If the Receiver or Transmitter are clocked directly from certain Line
Interface signals (RxC or TxC setup as inputs) and those Interface signals are setup as outputs, then the indicated parameters are required.
Optional [2]: Required only when the DPLL is part of the clocking tree setup.
Optional [3]: Required only when either Counter (CTR-0 or CTR-1) is directly clocking the Receiver, Transmitter, RxC or TxC signals.
Optional [4]: Only required when the clk_tree.A setting is CLK_DPLL (which is generally only used with Synchronous modes).
Optional [5]: Only required when the clk_tree.A or clk_tree.C setting selects a Baud Rate generator.
Optional [6]: Only required if CRC is enabled.