Tether installation – K-Edge K13-500-[color] User Manual
Page 4
4
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Tether Installation:
CAUTION:
THE K13-503 INSERT IS DESIGNED TO FAIL PRIOR TO FAILURE OF THE TABS ON THE BACK OF THE
GARMIN COMPUTER. SUCH FAILURES OCCUR IN THE EVENT OF A CRASH OR ABRUPT IMPACT EITHER WHILE
RIDING OR EXTERNAL CIRCUMSTANCES. THE USE OF A TETHER IS HIGHLY RECOMMENDED TO AVOID THE LOSS
AND/OR DAMAGE OF YOUR COMPUTER IN SUCH AN EVENT. IF YOU DO NOT HAVE A TETHER, ONE CAN BE
PURCHASED DIRECTLY FROM GARMIN (PART # 010-11251-16). THE INSTRUCTION BELOW IS A RECOMMENDATION,
ANCHORING AT THE MOUNT SHOULD ALWAYS BE MADE AT A RIGID POINT.
Tether Installation Steps:
1.
Attach the GARMIN Tether (Part # 010-11251-16) to your computer.
2.
Loop on the other end of the tether (As shown in the diagram above).
3.
Slide the loop over the head of the GARMIN mount arm and onto the ‘NECK’ (As shown in the diagram above).
4.
Synch the loop around the ‘NECK’ of the GARMIN mount arm.
5.
Install your computer onto the mount.
Tether Removal Steps:
1.
Remove your computer from the mount.
2.
Loosen the loop around the ‘NECK’ of the GARMIN mount arm.
3.
Slide the loop over the head of the GARMIN mount.