K-Edge K13-500-[color] - Manual (Page 5)

5
WARNING: IT IS STRONGLY RECOMMENDED THAT YOU PERIODICALLY CHECK ALL BOLTS FOR PROPER TORQUE!!!
Troubleshooting:
• My computer hits the front stem cap when I install/remove it from the mount.
o
Check the position of the mount and adjust as needed.
• My computer (Forerunner® 910XT) hits the arm of the K13-500.
o
Contact K-Edge for a spacer to properly space your 910XT.
• There is a little play even when my computer is installed onto the mount with a positive click.
o
With the computer installed, visually check for movement of the K13-503 from the openings underneath the
mount. If movement is detected slightly increase the torque of the 2x M3 x 6mm Flat Head Screws (1 N-m
Max).
• The mount moves downward when I install my computer.
o
Check that the proper amount of torque is applied to the 2x M4 x 12mm bolts on the clamp.
Support/Contact:
If problem(s) still persist after troubleshooting, please contact K-EDGE Support for further assistance at [email protected]
immediately. Please be sure to include your full name, phone number, and K-EDGE product purchased.