KERN & SOHN KET-TM - Manual (Page 194)

194 KEN-TM / KET_TM-BA-e-1420
21.3 How to connect the platform
 Disconnect the display unit from the power supply.
 Open housing
 To shield platform cable wind it around ferrite core [F].
 Solder the individual leads of the load cell cable onto the circuit board, see diagrams
below.
With 6 conductors:
Printed Circuit Board Load cell Remarks
E SHIELD
REF+ SENSE + JP1 unjumpered
REF- SENSE - JP2 unjumpered
IN+ OUTPUT +
IN- OUTPUT -
+5V INPUT +
GND INPUT -
Load cell
shi
el
d
[F]