Kuzma Stogi Reference - Manual (Page 12)

_________________________________________________________________
STOGI/STOGI REFERENCE 12 KUZMA
1. Ensure bias is on minimum.
2. Place protractor over spindle on platter. (Fig. 16)
3. Alignment at zero point 66 mm (A)
Place tip of stylus on point A (ie. zero point 66 mm). With a strong light observe cartridge
from front. The cantilever and the line on protractor (Fig. 17) should be in perfect
alignment.
If the cantilever is not then the body of the cartridge will have to be turned slightly. (Fig.
18)
Do not adjust cartridge by observing body of cartridge only.
HINTS: If you have difficulty seeing the cantilever it may help to raise the arm a
few mm. taking care that the protractor does not rotate. This also prevents
tilting of the cantilever due to the effect of bias force. It may also be helpful
to fix the platter by inserting a wedge between platter and plinth and by
inserting a sheet of white paper to give a clear background while observing
the cartridge.
To Adjust Cartridge
4. Slightly loosen the screws which attach the cartridge to the headshell.
5. Holding headshell in one hand slightly rotate the body of the cartridge.
6. Recheck alignment at position A and continue adjustment until line described in point 3 is
achieved.