Kuzma Stogi Reference - Manual (Page 8)

_________________________________________________________________
STOGI/STOGI REFERENCE 8 KUZMA
B. Mounting Cartridge
You will need Allen key 2.5 mm plus the two screws and nuts M 2.5.
1. Keeping stylus guard on cartridge, insert screws from undeneath cartridge through
slots in headshell and screw on the two nuts manually. (Fig. 9) The tip of the
cantilever should be level with the end of the headshell (viewed from side).
2. Fix by slightly tightening screws using Allen key. Ensure that nuts have fitted into
ledge around slots.
NOTE: It may be found easier to remove tube from armrest to give a little
more room.
3. Using tweezers, push the pin connectors into cartridge according to code
Red - right
Green - right ground
White - left
Blue - left ground
The connectors will slip snugly onto pins of the majority of cartridges, (Fig. 10)
however:
If pins are too fat with tweezers firmly push connector onto pin. Connector will
open slightly. Do be careful, however, that tweezers do not slip and damage
cantilever.
If pins are too slim then connectors should be squeezed with tweezers to make hole
slightly smaller. First squeeze as in A then as at B then slip connectors onto pins.
(Fig. 11)
4. Put cueing device into ‘play’ position, ie. down, release tube from armrest and
adjust counterweight until tube is balanced ie. floats in a horizontal position slowly
back towards the armrest. Prior to final balancing remove stylus guard. (Fig. 12)