Kuzma Stogi Reference - Manual (Page 6)

_________________________________________________________________
STOGI/STOGI REFERENCE 6 KUZMA
5. To fix base to armboard you will need the three socket head screws, spring washers
and Alley key 5 mm. Fit washers on screws and insert into underside of tonearm
board and up into tonearm base. (Fig. 4). Position base so that height adjustment
(VTA adjustment) screw is at top right position, i. e. 2 o’clock and tighten screws
using Allen key. Remember that screws are of harder material than tonearm (steel
and aluminium) so do not overtighten as this could damage base. (Fig. 5)
6. Replace tonearm board on turntable.
7. Insert tonearm cable through hole in base, then the pillar and fix at suitable height
using Allen key 3 mm at height adjustment screw in base. (Fig. 6)
8. Screw on counterweight so that thread is covered. This may take a little time.
9. It may now be necessary to adjust the suspension on the turntable due to the added
weight of the tonearm.
10. Fix tonearm cable onto turntable ensuring that there is adequate cable to allow for
height adjustment. If turntable has a suspended subchassis, position cable in such a
way that subchassis has freedom of movement.
11. The phono plugs are marked in the standard way: left - white, right - red, and
should be inserted into phono inputs. The connector at the end of the grounding
wire should be connected to GND on preamplifier.
12. Check that bias and thread are correctly positioned (it may have tangled during
handling). (Fig. 7)
13. For optimum performance you may wish to forego the convenience of the finger
lift. If so, this should now be removed using Allen key 0.7 mm, loosening screw
and easing out lift. Replace screw in hole. (Fig. 8)