Kuzma Stogi Reference - Manual (Page 5)

_________________________________________________________________
STOGI/STOGI REFERENCE 5 KUZMA
IV. MOUNTING AND ADJUSTING
A. Mounting Tonearm
1. Take tonearm mounting protractor and place on spindle of turntable. The cut-out is
similar to standard Linn cut-out. (Fig. 1)
2. Mark position of holes as indicated on protractor on tonearm mounting board.
Ensure that there is adequate space in front for tube and headshell and behind for
counterweight, in order to avoid problems of lid closure. Check also that screw
positions will be over cut-out on subchassis, unless screws are to be sunk. It is wise
before cutting to hold tonearm in position over marks and judge if position of
tonearm on board will be correct, bearing in mind these criteria. (Fig. 2) Otherwise
precise position of tonearm is unimportant providing it lies on protractor arc.The
height of tonearm with cartridge mounted is 55 mm above record. (Fig. 2 a).
3. Remove tonearm board from turntable.
4. Check that thickness of board is between 6 mm and 12 mm, if so make cuts as
marked.
NOTE: If board is thicker than 12 mm
Either a) obtain screws of length that will go through armboard and into base to a
depth of approximately 5 mm, remembering washer or
b) sink the screw heads by first drilling a large hole of about 9 mm with drill and then
drilling hole of smaller dimension through this. (Fig. 3)