LABEC AA-12BS - Manual (Page 10)

Operation manual
Series Steam Sterilizers
6
7 DRY key
8 STEP key
9 START/STOP key
12 RUNNING indication light
11 READY indication light
10 WATER indication light
When you choose the right program, push this button then it starts a cycle. Keeping
pressing the key 3seconds before desiccation phase, the cycle of sterilization will be
quitted. Then it will enter 3 minutes dryness. In this program if you press the key again,
the program of dryness will be over at any moment. If you press the key at the end of
dryness, the cycle will be quitted directly.
Working light. It means sterilize program is working .
When the light goes on, the machines gets ready for sterilization,and the operator can press
start key to start a cycle.
When the water volume is low, the light is glinting.
This is a post cycle selection key. When a sterilize cycle completes, you may press this
key to keep on working or stop working The indication light goes on, and it means that
when the cycle is complete, the heating element will stop before the chamber door is
opened. When the indication light is off, it means that the chamber will be kept warm
after completing a cycle and heating up time is shorter during next cycle. If you don’t
want to start the last cycle, you need to press
STEP key once.Then the indication
light will be off.
This key selects the Fast sterilization cycle. With unwrapped instruments, you may use
the fast cycle by pressing the DRY key once, the indication light goes on and it indicates
that machine is in fast cycle mode.
, you may still use
this selection to shorten the cycle time.
Using autoclave made by us