Longshine LCS-US204 - Manual (Page 11)

11
10. Click Submit to save your settings. And the server will reboot.
11. You have now finished the procedure of setting the wireless parameters.
After properly configuring the wireless parameters, you can remove the network
cable and reboot LCS-US204. LCS-US204 will then connect to your wireless network.
LCS-US204 will detect if a network cable is plugged-in or not. If a network cable is
plugged-in, LCS-US204 will always connect to the network through the network
cable. Otherwise it will always connect to the network through wireless module.
Once LCS-US204 connects to the network, either by network cable or by wireless
module, all operations to use USB device server are exactly the same.
3.3 Assigning an IP Address to the Server
3.3.1 Preliminary
If you have a DHCP server on your network, your Server will receive an IP
address automatically. The IP address will then appear on the Control Center
or on the page of configuration report that you printed earlier. If your DHCP
server does not give an IP address to the Server, the Server will use the
automatic private IP addressing IP: 169.254.0.0. ~ 169.254.255.255
If you are not working in a DHCP network, you need to manually set the
Server’s IP address.