Longshine LCS-US204 - Manual (Page 19)

19
D.
Now, PC will detect the plug-in of the USB device. The “connect” operation is a
software operation that simulates an actual USB device plug-in. That is to say,
when you do a “connect” operation in the Control Center, PC can then detect a
USB device’s plug-in, although actually you do not plug in any USB device.
E. Then, just use the USB device as if it is connected directly to your PC’s USB port.
F. After you finish using the USB device, click the USB device in the Control Center
and then click the “Disconnect” button to disconnect the USB device. Other PCs
can not “Connect” the USB device until you “Disconnect” that USB device. That is
to say, only one PC is allowed to connect the USB device at the same time.