MF Digital Vantage (Rev: 06/01/02) - Manual (Page 18)

Vantage Series
Operator’s Guide
Document Revision: 110102
Page 17
Installing The Printer Support
The printer support bracket must be installed before the printer is installed. The bracket
attaches with six fasteners and extends from the back of the unit as depicted below.
Attaching The PDS (printer docking station) To The Vantage
• Loosen the screws from the back of the unit about half way, if already in
place. Align the slots of the bracket with the mounting screws on the
rear of the unit. Slide the bracket down over the mounting screws.
Fasten the bracket in place by tightening the screws clock-wise.