Motion Pro 08-0294 - Manual (Page 2)

Section 2. Rocker Pivot
Every manufacturer has a slightly different suspension linkage system. The examples here are performed
on a 2006 CRF450R. Refer to your shop manual for any specific instructions or procedures that are not
covered here.
g. Assemble the bearing driver as shown in Fig 4.
Tighten screw until the driver bottoms out on the
inside bearing surface.
a. Remove all seals and inner spacers from
the rocker
b. Using the appropriate bearing remover,
assemble the tool as shown in Fig 5. If you do
not have a bench vise you can use a wrench
on both nuts.
c. Tighten the nut until the bearing is pushed
completely out of the rocker and into the
bearing cup.
d. Clean all bearing surfaces and inspect for
damage.
e. Install bearing onto the corresponding bearing
driver as shown in Fig 6. The bearing driver will hold
the loose needles in place during installation.
f. Assemble the bearing driver as shown in Fig 4.
Tighten screw until the driver bottoms out on the
inside bearing surface.
g. Reinstall all seals and bearing spacers. Be sure to
pack the new bearings with a high quality grease
before reinstalling the components onto the
motorcycle.
Fig 4
Fig 5
Fig 6
I08-0294A 5/2009