Motion Pro 08-0294 User Manual

Page 3

Advertising
background image


Section 3. Connecting Link

Again, most manufacturers have a slightly
different suspension linkage system.
The examples here are performed on a 2006
CRF450R. Refer to your shop manual for
any specific instructions or procedures that
are not covered here.








































a. Remove all seals and inner spacers.

b. Fully tighten the blind bearing remover on
the inner lip of the needle bearing then
assemble the tool as shown in Fig 7. Be sure
that the lip of the blind bearing remover is fully
engaged on the bearing.

c. Apply a small amount of grease onto the
threads of the puller and washer

d. Remove bearing as shown in Fig 8.

e. Clean all bearing surfaces and inspect for
damage.

f. Assemble the bearing driver as shown in Fig
9 and Fig 10. Tighten screw until the driver
bottoms out on the inside bearing surface

g. Install new greased bearing onto the bearing
driver and assemble the tool as shown in fig 9
and 10

h. Replace all seal, inner spacers, and clips.

Fig 7

Fig 8

Fig 9

Fig 10

I08-0294A 5/2009

Advertising