Motion Pro 08-0415 - Manual (Page 3)

I08-0415 3 of 4 03/2010
7 7
7. To refill your SyncPRO™, hold the reservoir upright so that the chambers are vertical. Insert the
tip of the refill bottle all the way in past the threads of the first chamber and place 35 drops of
manometer fluid into the chamber. This should result in a fluid level measurement of
approximately 5/8” down from the top front edge of the reservoir. (Note: It is important to keep
the fluid off the threads.)
Fill each of the remaining chambers using the same method until the fluid level is equal to the
first chamber (NOTE: filling of remaining chambers may take more or less than the 35 drops to
be equal in height to the first chamber).
When finished filling, perform a visual check to make sure the fluid levels in the four chambers
are the same height. If the fluid levels are not the same height, add a drop of fluid to the
chambers that are low until they are all approximately the same. If you overfill a chamber or
get fluid on the threads you can use a lint-free cloth to wick up or wipe away any excess fluid. If
there is fluid in the threads, make sure to wipe them dry before installing the piston.
6. Install the vacuum caps about halfway down
onto the tubes to create an air seal.
6