Motion Pro 08-0415 - Manual (Page 4)

I08-0415 4 of 4 03/2010
9
.
9. Place the reservoir in the housing, and check one last time that the o-rings and tubes are still fully
seated before you put the housing back together. Starting with the innermost screws and working
outward, gently hand-tighten each screw until the housing is closed around the entire perimeter.
Replace the rubber feet. Your SyncPRO™ is now ready for use. Remember to check and set
your engine idle to the proper RPM before hooking up the SyncPRO™ for its next use.
8. Make sure the calibration screws and o-
rings are free of debris and then thread
them down gently by hand until they
bottom out. They do not need to be
tight.
8