Motion Pro 08-0468 wave - Manual (Page 2)

Additional Features (Cont.)
Setting AUTO-OFF Timer
With the unit turned “on” and 0.0 displayed, press and hold the FUNCTION button for 5 seconds until - - 2 – appears. Release the
FUNCTION button. Four choices of timer setting will alternately be displayed, 180, 240, 300 & 360 seconds. Press the ON/OFF button
when the desired time is displayed. The selected time will then flash, –End will momentarily be displayed, and the gauge display will
return to 0.0. The gauge is now ready for use.
Setting AUTO-OFF Method
It can be annoying to have the gauge auto-off in the middle of checking a tire’s pressure. This setting will allow the user to set the
gauge to ignore the auto-off feature when the gauge has pressure.
With the unit turned “on” and 0.0 displayed, press and hold the FUNCTION button for 5 seconds until - - 3 – appears. Release the
FUNCTION button. The numbers 1 and 0 will alternately be displayed. Press the ON/OFF button when the desired mode is displayed.
1 : The gauge will not auto-off when sensing pressure. If no pressure, gauge will auto-off after the programmed auto-off time.
0 : The Gauge will auto-off after set auto-off time.
The selected mode will then flash, –End will momentarily be displayed, and the gauge display will return to 0.0. The gauge is now ready
for use.
BATTERY REPLACEMENT
The 08-0468 Motion Pro Digital Gauge uses two “AAA” to power the unit. To replace the batteries in the gauge after they no longer
have sufficient power, carefully slip the rubber boot back over the gauge exposing the gauge back. Open the rectangular battery com-
partment lid by dressing the clip and pulling the lid outward exposing the batteries. Remove the old batteries and install new batteries
paying close attention to proper battery direction. Place the lid back into place and snap closed. Return the rubber boot to its original
position and the gauge is now ready for use.
Warranty
This product is guaranteed against defects in quality and workmanship for a period of two years from the date of purchase.
All products being returned to Motion Pro for warranty consideration must be accompanied by a Return Goods Authorization number
(RGA#). Please contact the Motion Pro Warranty Department at 650-594-9600 between 8am-5pm pst to obtain a RGA#. Please do
not send any product to Motion Pro without an RGA#.
All gauges will be inspected for warranty eligibility upon receipt. External signs of abuse or damaging the gauge with excessive pressure
will not be covered by warranty.
This warranty is limited to repair or replacement at the sole discretion of Motion Pro, Inc.
The above is the customer’s exclusive remedy. The above is in lieu of all warranties expressed or implied and of all other obligations
and liabilities. In no event shall Motion Pro, Inc. be liable for any incidental or consequential damages arising from the breach of any
warranties, improper use, the failure to deliver, delay in delivery, delivery of non-conforming parts, or any other breach of contract or
duty.
I08-0468 6/2013