Motion Pro 11-0055 - Manual (Page 3)

I11-0055 3 10/2010
Fig. 5
6. Snap pin connecters into the black two pin coupler and make sure the rubber seals are
recessed in the connector (Fig. 6 & Fig. 7).
Fig. 6 Fig. 7
7. Replace front fender and reconnect the safety tether and connect the pre-start button
to the same connecter plug that the thumb throttle safety switch plugs into.
STARTING PROCEDURE,
1. Turn on ignition switch and slide on-off switch to the on position.
2. Push pre-start button.
3. Start engine as per manufacturer’s procedure.