Neu-F NF.1525 - Manual

neu-f ® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
[email protected] • www.neu-f.com
PARTS LIST: TOOLS REQUIRED:
1 – 25mm Anti-Roll Bar 2 – Bushing Clamp w Base Plate 1 – 10mm Socket 1 – 15mm Socket 1 – 16mm Wrench
2 – 25mm Urethane bushing 4 – M8 x 25mm Flange Bolt 1 – 18mm Socket 1 – E12 Socket (External Torx) 1 – E18 Socket (External Torx)
1 – Synthetic Grease 1 – 21mm Socket
1. Park car on a flat, level surface capable of
supporting the vehicle’s weight on jack and jack
stands. Note: Car hoist recommended. Using the
manufacturer’s recommended lifting point(s), raise
front of vehicle and support with jack stands.
NEVER WORK ON A VEHICLE SUPPORTED ONLY
WITH A JACK!
2. Remove front wheels.
3. Using 16mm wrench, disconnect end-link from anti-roll bar.
4. Using 15mm socket remove the side frame to sub-frame
brace on both sides of vehicle.
5. Remove the plastic lower engine cover, there are (6) 10mm
hex bolts.
6. Sub-frame bolt identification and location.
7. Remove the (4) anti-roll bar bushing clamp bolts up thru
holes in sub-frame using E12 socket.
8. Remove the (2) steering rack bolts using E18 socket.
9. Remove the (2) side sub-frame bolts using E18 socket.
10. Remove the (4) lower cross-bar bolts using 18mm hex
socket.
11. Remove the (4) rear sub-frame bolts using 21mm hex
socket.
12. Remove original anti-roll bar out towards rear of vehicle.
Rotate ends down and pull out passenger side first.
Note: Extra person pulling down on sub-frame will ease
removal.
13. Neu-F Anti Roll Bar: Install driver’s side of bar over exhaust,
then with ends pointing down snake passenger side up into
position. Once again have extra person pulling down on
sub-frame to ease installation. NOTE: Leave plastic wrap
on during installation will help protect powder-coat finish
during installation.
FRONT ANTI-ROLL BAR - 25MM – NF.1525
Fits 2012-up Fiat 500 All Models