New England Arbors Canvas Weave - Manual

10 x 10 Canvas Weave
A S S E M B LY I N S T R U C T I O N S
Ver 1.0/JAN 2013
www.newenglandarbors.com
This kit contains five strips of canvas that is designed to fit the 10 x 10 Flat Top Pergolas. Models include the Venetian, Luxor, and Tuscany
Pergolas. No hardware is required to attach the canvas to the shade slats of the pergola as velcro strips are already sown in at the ends of
the canvases.
Check the box and make sure you have five strips and that the male-female velcro orientation is correct. In the event of missing or defective
parts, please call our customer service department at 1 800 282 9346 extension #20 (Monday to Friday. 8:00 AM to 4:00 PM EST).
S T E P S
Layout all five strips of canvas and check the ends to make sure there are a female and male velcro strip on both ends as shown.
With the velcro strips facing up, weave the canvas through the shade slats as shown. Note the pattern of the weave (below two shade slats,
and above two shade slats). Starting with below one shade slat, and ending with the same.
For the middle canvas, you will need to remove the shade slat couplers.
The ends of the canvases would then wrap around the end shade slats and be secured with the velcro.
Note: Canvas strips should be removed under heavy wind or snow to prevent any ripping or damage.
Male and Female Velcro Strips
Shade slat couplers
need to be removed.
Weave with velcro facing up.
End of canvas wraps around
the end shade slat as shown.