New England Arbors VA94433 User Manual

The portsmouth/charleston lamp post, Check box for these contents, Tools you will need

Advertising
background image

Check Box for These Contents

In the event of missing or defective parts please call our customer service dept. at 1 800 282 9346, ext #20 (Mon. to Fri. 8:00 AM to 4:00 PM EST).
1. Lamp Post Top (1) 5” x 5“ x 14”
2. Post Coupler (1)
3. Lamp Post Bottom (1) 5” x 5“ x 58”
4. Post Cap (1)
5. Post Collar (1)
6. Base Molding Trim Cap (1)
7. Base Molding Post (1)
8. Base Molding Bottom Insert (1)
9. 1-1/2” Screws (4)
10. Vinyl Weld Glue (1)

Tools You Will Need

• Wheelbarrow or bucket (to mix concrete)
• Tape Measure
• Level
• Shovel

Purchased Separately

• Lamp.
• 4x4 Pressure treated lumber. - 8’ long
• Two bags of pre-mix concrete. *
* Strongly recommended for the stablility of this product.

General Information

Read Instructions through carefully before beginning assembly.
• When handling components, place on a non-abrasive surface
(i.e. shipping box)

to avoid scratching.

• We recommend an area approx 10’x 8’ for unobstructed handling.

Important Note:

• Please refer to local codes before installing outdoor lighting. UF-rated cable should be used for underground
wiring and all materials should be approved by the Underwriter’s Laborator (UL). New England Arbors
assumes no liability for errors, ommissionsm or the outcome of any project.

The Portsmouth/Charleston Lamp Post

Please read through before starting assembly.

A S S E M B LY I N S T R U C T I O N S

1

Ver 5/JUL 2013

9

Not to Scale

 

 

5

1

4

10

7

8

3

2

6

Advertising