New England Arbors VA94433 - Manual (Page 2)

2
S T E P O N E
Apply a generous amount of vinyl glue to the ribbed surface of the post
coupler as shown and join the two posts as illustrated.
Slide the base molding over the lamp post.
Slide the post collar down measuring 12 inches from the top of the post.
Once desired height is achived, make a note of the position of the collar.
Slide the collar UP and out of the way, then apply a generous amount of
vinyl glue at the top of where the collar would sit.
Slide the collar back down to its desired height and allow some time for
the vinyl glue to set and cure.
Apply a generous amount of vinyl glue to the inside base of the post
cap and place over the top end of the lamp post as illustrated.
Lamp Post Assembly
S T E P T H R E E
B
Wood Post Installation
Dig 36 in. deep hole in the desired location. Verify the depth of the
hole to ensure that the 4x4 wood post will be buried 36 in. into the
ground. Fill the hole 3/4 full with pre-mix concrete (not included).
Insert the post into the concrete and check for level. Allow time for the
concrete to set, then fill in the remainder of the hole.
3
36”
Level
6“ 6“
2
✁ ✂
B D C A
A
B
C
E
D
1
S T E P T W O
Base Molding Assembly
Apply a generous amount of vinyl glue to the underside of the base
molding and the top side of the base molding bottom insert and
attach to the base molding post as shown aside.
E