Calibrating boom geometry – NORAC UC5-BC-AGCO-RMC User Manual
Page 46
Advertising
46 |
5.6.4. Calibrating Boom Geometry
1. Ensure the sprayer is over bare level soil or gravel.
2. Ensure the boom is level and approximately 1 to1.5m (3 – 5 feet) above the ground.
3. Navigate to the boom geometry test (Run Screen-> Settings-> Next-> Next-> Setup-> Boom
Geometry Test).
4. The booms will be moved into position and, the display will prompt you to exit the cab and manually
push either boom tip down. Stay at least 3 feet from the sensor.
5. Push either boom tip down 1 – 3 feet (30 – 90 cm) for a moment and then let go. Do not push the
boom to the ground.
Advertising