OFM 680 - Manual

B
Chair Base
1 Unit
A
Chair Body
1 Unit
H
Allen Wrench
1 Unit
C
Casters
5 Units
D
Gas Lift
1 Unit
E
Telescopic Bellows
1 Unit
F
Hinge Pin
2 Unit
G
Pin Screws
2 Units
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 680
Power Rest Executive Recliner
WEIGHT CAPACITY: 250 lbs.
Parts Listing
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Insert Casters (C) into Chair Base (B).
Step 2: Insert Gas Lift (D) into Chair Base (B) and cover with
Telescopic Bellows (E).
Step 3: Unfold back section of Chair Body (A) and bring to upright
position, aligning the hinges on the back section and seat
section underneath the vinyl flap.
Step 4: Insert Hinge Pins (F) facing inward through the hinges on
both sides.
Step 5: Secure by screwing Pin Screws (G) with Allen Wrench (H)
through the holes in the end of the Hinge Pins (F).
Step 6: Zip the vinyl flap closed.
Step 7: Place Chair Body (A) onto Chair Base (B) by inserting top
of Gas Lift (D) into the metal hole in the bottom of the
Chair Body (A). Carefully sit on seat to secure to base.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
06.25.2010
A
H G
F
E
D
B
C
To Extend Footrest
Step 1: With fingertips, find metal
handle under Footrest.
Step 2: Pull Footrest out and lift up
until it locks into position.
Swivel Footrest down.
To Stoor Footrest
Step 1: Grasp the Footrest in the center
and pull up to a vertical position.
Step 2: Push the Footrest down and back
until it is tucked under the seat.