OFM 508-LX User Manual

Model 508-lx, Encore series leatherette mid-back chair, Assembly instructions

Advertising
background image

Model 508-LX

Encore Series Leatherette Mid-Back Chair

Parts Listing

Assembly Instructions

Tools Needed: Allen Wrench

Please read all instructions before assembly.
Step 1: Insert Casters (D) into Chair Base (E). Insert Gas Lift (G) into hole in

Chair Base (E). Cover Gas Lift (G) with Telescopic Bellows (H).

Step 2: Attach Arm Rests (C) to sides of Chair Seat (B) using 6mm Screw (I).

Tighten with Allen Wrench.

Step 3A: Attach Chair Back (A) to Arm Rests (C) using 6mm Screw (I).

Tighten with Allen Wrench.

Step 3B: Cover screw holes with Screw Caps (K). Press in firmly.
Step 4: Attach Seat Mechanism (F) to the bottom of Chair Seat (B) using

6mm Screws (I) and 6mm Washers (J).

Step 5: Place chair body onto Chair Base (E) by inserting top of Gas Lift (G)

into hole in the center of Seat Mechanism (F). Press down firmly on

Chair Seat (B) to secure onto Chair Base (E).

STOP

919-362-4765 (fax)
www.ofminc.com

161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]

Assembly Notes:

During assembly, hand tighten screws only. When all screws

are in place, you may then tighten all screws completely.
CAUTION:

1. Do not use this chair as a step ladder.

2. Check for loose screws and tighten them every 6 months.

WEIGHT CAPACITY: 250 lbs.

05.12.2014

F

Seat Mechanism

1 Unit

E

Chair Base

1 Unit

G

Gas Lift

1 Unit

H

Telescopic Bellows

1 Unit

5

B

Chair Seat

1 Unit

A

Chair Back

1 Unit

C

Arm Rests

2 Units

D

Casters

5 Units

J

6mm Washer

4 Units

K

Screw Cap

8 Units

2

B

C

I

I

J

F

4

3

I

A

K

1

H

G

E

D

I

6mm Hex Screw

12 Units

L

Allen Wrench

1 Unit

Advertising