OFM 518-LX - Manual

B
F
G D
2
Model: 518-LX
Stimulus Series Leatherette Guest Chair
Parts Listing
H
Arm Caps
4 Units
G
Allen Wrench
1 Unit
B
Chair Seat
1 Unit
A
Chair Back
1 Unit
1
B
F
G
A
3
A
H G
E
C
STOP
C
Chair Arms
2 Units
D
Chair Base
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
WEIGHT CAPACITY: 250 lbs.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
11.13.2014
E
6x50mm Screws
4 Units
F
6x25mm Screws
8 Units
Assembly Instructions
Please read all instructions before assembly.
Tools Needed: Allen Wrench included.
Step 1: Place Chair Seat (B) upside-down on a level, non-abrasive
surface. Align the pre-drilled holes in the bar at the bottom
of the Chair Back (A) with the corresponding holes in the
Chair Seat (B). Attach them to each other with the 6x25mm
Screws (F). Tighten using Allen Wrench (G) provided.
Step 2: Attach Chair Base (D) using 6x25mm Screws (F) and tighten
with Allen Wrench (G) provided.
Step 3: Attach Chair Arms (C) to Chair Back (A) and Chair Seat (B)
using 6x50mm Screws (E) and tighten using the Allen
Wrench (G) provided. Cover screw holes with Arm Caps (H).