OFM 405-VAM - Manual

403
405
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model: 403 / 403-VAM / 405 / 405-VAM
Guest / Reception Chairs
WEIGHT CAPACITY: 250 lbs.
Parts Listing
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Mount both sides of Seat Cushion (A) onto
the bottom rib of the steel frame (C or D), with special
coated Ni-Lock Screws (E) and tighten with screwdriver.
Step 2: Place the Back Cushion (B) onto the back rib on top
of the side Steel Frame (C or D), attach it with the
Hex Screws (F) and tighten with screwdriver.
F
6 mm Hex Screws
4 pcs.
E
M8 Ni-Lock
Hex Screws
8 pcs.
A
Seat Cushion
B
Back Cushion
C
Steel Frame
Armless
1 pair
D
Steel Frame
with Arm
1 pair
1
C/D
E
A 2
F
B
12.23.2013
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-362-4765 (fax)
919-303-6389 (voice) www.ofminc.com
[email protected]