OFM 408-VAM - Manual

A
Seat Brace
2 pcs.
B
Left and Right Side
2 pcs.
E
8mm Screw
4 pcs.
D
Washer
8 pcs.
G
6mm Screw
4 pcs.
H
Back Hardware
Cover
2 pcs.
C
Chair Seat
1 pc.
F
Back Rest
1 pc.
I
Model 404CAS
Optional Caster
4 pcs.
A
B
E
D
G H
D
H
B
C
F
I Casters can be
purchased separately.
Assembly Instructions
Tools needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Attach Seat Braces (A) to Left and
Right Sides (B), making sure that the pre-drilled
holes in braces align with the holes in arms.
Step 2: Attach the Chair Seat (C) to the frame
by placing four Washers (D) onto four 8mm
Screws (E), and inserting them through the
Seat Braces (A) and into the Chair Seat.
NOTE: Hand tighten screws only .
Step 3: Attach Back Rest (F) to the frame by
placing four Washers (D) onto four 6mm
Screws (G), and inserting them into the frame
and into the Back Rest.
NOTE: Hand tighten screws only .
Step 4: Proceed to tighten all screws on Chair
Seat and Back Rest with screwdriver.
Step 5: Place Back Hardware Cover (H), over
the 6mm Back Rest Screws (G). Slide cover
over frame and snap into place.
For installation of Model 404CAS ONLY!
404CAS Optional Caster Installation:
Step 6a: Lay chair down on level, non-abrasive
surface and insert Model 404CAS Optional
Casters ( I ), into the fittings in the legs, making
sure casters are securely inserted into the legs.
STOP
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
WEIGHT CAPACITY: 250 lbs.
Parts Listing
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-362-4765 (fax)
919-303-6389 (voice) www.ofminc.com
[email protected]
Models: 404 / 404-VAM
Guest/Reception Chair with 404-CAS optional casters
408 / 408-VAM
12.23.2013