OFM 310-VAM-A - Manual

C
A
D
B
D
E
Ganging Brackets are standard on all
Model 310-F/310-P/310-VAM Chairs
Assembly Notes:
During assembly, hand tighten screw only when all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 310-VAM / 310-VAM-A
Multi-Use Stack Chair with Vinyl Seat & Back
WEIGHT CAPACITY: 250 lbs.
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Step 1: Place Chair Seat (B) onto Chair Base (A),
and align screwholes. Insert Screws (D)
to secure. Tighten with a screwdriver.
Step 2: Slide Chair Back (C) onto posts of Chair Base (A).
Align holes and insert Screws (D) to secure.
Tighten with a screwdriver
With Optional Arms (E):
Step 1: See Step 1 above.
Step 2: Slide Chair Back (C) onto posts of Chair Base (A).
Step 3: Slide A310 Arms (E) onto sides of Chair Back (C).
Step 4: Align holes in arms, back and base and insert
Screws (D) to secure. Tighten with a screwdriver.
Note:
Once Model A310 Arms are added chair is no longer able
to stack.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
03.30.2010
A
Chair Base
1 Unit
B
Chair Seat
1 Unit
C
Chair Back
1 Unit
D
Screws
6 Units
E
Model A310 Arms
Optional
2 Units
Parts Listing