OFM 1007W - Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Check for loose screws and tighten them every 6 months.
Models 1006W / 1007W
Retro Bench
WEIGHT CAPACITY: 500 lbs. Per Bench
Parts Listing
STOP
Assembly Instructions
Tools Needed: Adjustable Wrench, Allen Wrench
Please read all instructions before assembly.
Step 1: Slide Post Covers (H) over legs of H-Frames (B) as shown.
Step 2: Screw in Anchoring Plates/Leveling Glides (I) to bottom of H-Frame legs (B).
Step3: Align holes in H-Frames (B) with the corresponding holes in the Cross Bar (C). Insert 10x85mm Bolts (J) through the 56mm
Bolt Sleeves (M) and into the 10mm Nuts (Q) for vertical connections. Insert 10x55mm Bolts (K) through 36mm Bolt Sleeves (L)
into the 10mm Nuts (Q) for horizontal connections. Tighten with Allen Wrench and Adjustable Wrench.
Step 4: Align holes in Cross Bar (C) with the corresponding holes in the Inclined Support Bar (E) and Vertical Support Bar (F).
Insert 10x85mm Bolts (J) through 56mm Bolt Sleeves (M) into inside of Vertical Support Bar (F) for vertical connections.
Insert 10x55mm Bolts (K) through 36mm Bolt Sleeves (L) into 10mm Nuts (Q) for horizontal connections.
Tighten with Allen Wrench and Pliers.
Step 5: Align Bench Brackets (G) with H-Frames (B) and attach using 10x25mm Screws (O) and 10mm Nuts (Q). Tighten with Allen
Wrench and Adjustable Wrench.
Step 6: Align Benches (D) with Bench Brackets (G) and attach using 8x12mm Screws (N). Tighten with Allen Wrench.
Step 7: Align Table Top (A) with Vertical Support Bar (F) and attach using 8x12mm Screws (N). Align Inclined Support Bar (E) with
Table Top (A) and attach using 10x30mm Screws (P). Tighten with Allen Wrench.
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC 27540
800-520-7471 (voice)
919- 303-6389 (voice)
[email protected]
09.14.2010
I
Anchoring Plate/Leveling Glide
with Anti-Skid Rubber Pad
4 Units
H
Post Covers
4 Units
A
Table Top
1 Unit
D
Benches
2 Units
M
56mm Bolt Sleeve
3 Units
L
36mm Bolt Sleeve
6 Units
J
10x85mm Bolt
3 Units
O
10x25mm Screw
8 Units
N
8x12mm Screw
18 Units
Q
10mm Nut
14 Units
P
10x30mm Screw
4 Units
K
10x55mm Bolt
6 Units
8mm Allen Wrench
1 Unit
5mm Allen Wrench
1 Unit
G
Bench Brackets
4 Units
B
H-Frames
2 Units
C
Cross Bar
1 Unit
E
Incline Support Bar
1 Unit
F
Vertical Support Bar
1 Unit
I
H
K L
Q
G
M
J
M
J
B
O
A
E
P
D
F
D
C
N
N