OFM 420 User Manual

Model: 420, Uno lounge chair, Assembly instructions

Advertising
background image

5mm Allen Wrench

1 Unit

A

Back Cushion

1 Unit

B

Seat Cushion

1 Unit

C

Frame / Legs

2 Units

D

Screws

8 Units

Assembly Notes:

During assembly, hand tighten screws only. When all screws

are in place, you may then tighten all screws completely.
CAUTION:

1. Do not use this chair as a step ladder.

2. Check for loose screws and tighten them every 6 months.

Model: 420

UNO Lounge Chair

WEIGHT CAPACITY: 250 lbs.

Parts Listing

12.23.2013

A

C

F

G

E

B

D

STOP

Assembly Instructions

Tools Needed: Allen Wrench and a Standard Screw Driver.
Step 1:
Insert the Frame/Legs (C) into the large holes in

the Back Cushion (A) and the large holes in the

Seat Cushion (B) as shown.

Step 2: Align the holes in the Frame/Legs (C) with the

corresponding holes in the Back Cushion (A)

and Seat Cushion (B).

Step3: Insert Screws (D) through the holes in the

Frame/Legs (C). Tighten by hand.

Step 4: When all screws are in place, tighten with Allen

Wrench.
Step 5: If applicable, attach Ganging Bracket (E) to

Frame/Legs (C) using Ganging Bracket Screw (F)

and Ganging Bracket Nut (G). Tighten using

Screw Driver.

F

Ganging Bracket Screw

2 Units

E

Ganging Brackets

2 Sets

G

Ganging Bracket Nut

2 Units

Follow us on facebook at facebook.com/ofminc

Tweet with us on twitter at twitter.com/ofminc

Watch us on youtube at youtube.com/ofminc

161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)

919-362-4765 (fax)

919-303-6389 (voice) www.ofminc.com
[email protected]

Advertising