OFM 421 User Manual
Model 421, Uno pillow-back seat, Assembly instructions
A
Seat Cushion
1 Unit
B
Connector Bar
2 Units
D
8x60mm Screw
4 Units
E
8x25mm Screw
6 Units
C
Frame / Legs
2 Units
Assembly Notes:
During assembly, hand tighten screw only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this chair as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 421
UNO Pillow-Back Seat
WEIGHT CAPACITY: 250 lbs.
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail
.
Holly Springs, NC, 27540
800-520-7471 (voice)
.
919- 303-6389 (voice)
.
08.01.2011
STOP
Assembly Instructions
Tools Needed: Allen Wrench
Step 1: Attach the Connector Bars (B) to the Legs (C)
by inserting 8x60mm Screw (D) through bars and
into legs using an allen wrench.
Step 2: Align the holes in the Connector Bars (B) with the
corresponding holes in the Seat Cushion (A).
Step3: Attach by inserting 8x25mm Screws (E) through
Bars (B) and into the Seat (A) using an allen wrench.
C
B
A
D
E