OFM XTC - Manual

161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-362-4765 (fax)
919-303-6389 (voice) www.ofminc.com
[email protected]
A
Table Top (Round or Square)
1 Unit
B
Mounting Plate
1 Unit
F
Mounting Plate Bolts
4 Units
G
Threaded Rod Nut
1 Unit
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model XT Tables / XTC Tables
Standard and Café Height X-Style Base Tables
Parts Listing
01.06.2014
STOP
Assembly Instructions
Tools Needed: Allen Wrench, Adjustable Wrench
Please read all instructions before assembly.
Step 1:
Place the Table Base (C) securely on a flat, clean
surface. Insert the Threaded Rod (G), with the attached
nut on the bottom, into the hole in the center of the
Table Base (C) and tighten with adjustable wrench.
Step 2: Cover the Threaded Rod (E) with the Center Post (D)
and securely fit Center Post (D) onto Table Base (C).
Step 3: Place Mounting Plate (B) down on top of the Center
Post (D), making sure to thread the top of the
Threaded Rod (E) through the center hole in the
Mounting Plate (B). Make sure the Mounting Plate (B)
is square with the base, and secure by placing the
Threaded Rod Nut (G) onto the end of the Threaded
Rod (E) and tightening with an adjustable wrench.
Step 4: Attach the Table Top (A) by placing it down onto the
Mounting Plate (B), as shown, and secure by aligning
the holes in each and inserting Mounting Plate Bolts (F)
through the Mounting Plate (B) and into the bottom of
the Table Top (A). Tighten with an Allen Wrench.
Note: If table seems to wobble, adjust the built-in leveling glides
on the base to make the table secure.
C
Table Base
1 Unit
D
Center Post
1 Unit
E
Threaded Rod
1 Unit
A
G
B
F
D
E
C