OFM 66248 - Manual

Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 66248
Mesa Series Media Terminal/Workstation
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
01.16.2014
STOP
Assembly Instructions
Tools Needed: Allen Wrenches (provided)
Please read all instructions before assembly.
Step 1: Place Table Legs (B) on the underside of Table Top (A).
Attach by inserting 6x55mm Screws (G) through Table Legs (B)
and into Table Top (A). Align the holes on each Support Rail (C)
with the holes on Table Top (A) and insert 6x55mm Screws (G)
through each Support Rail (C) and into Table Top (A). Attach
Corner Leg Bracket (I) to one hole in Support Rail (C) and one hole
in Table Legs (B), and insert 10x35mm Screw (H) through bracket
and into legs. Tighten using Large Allen Wrench (E).
Step 2: Insert Hardware Box (J) into the hole on Table Top (A). Attach
Brace (K) to Hardware Box (J) with 4x6mm Screw (F) from
underneath the table to secure in place.
A
Table Top
1 Unit
B
Table Legs
2 Units
C
Support Rail
2 Units
1 2
D
Small
Allen Wrench
2 Units
F
4x6mm Screw
1 Unit
E
Large
Allen Wrench
2 Units
G
6x55mm Screw
16 Units
H
10x35mm
Screw
4 Units
J
Hardware Box
1 Unit
K
Brace
1 Unit
G
D
E
I
H
C
C
A
B
B
F
I
Corner Leg Bracket
4 Units
J
K