OFM 66266 - Manual

A
Desk Top
1 Unit
G
10x35mm Screw
4 Units
B
Side Panel Legs
2 Units
C
Pedestal
2 Units
D
Privacy Panel
1 Unit
E
Corner Leg Bracket
4 Units
I
Allen Wrench
1 Unit
J
Phillips Head Screw Bit
1 Unit
F
6x55mm Screw
8 Units
H
6x16mm Screw
8 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this credenza as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model 66266
Mesa Series Double Pedestal Credenza
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
01.13.2014
STOP
Assembly Instructions
Tools Needed: Phillips Head Screwdriver
Please read all instructions before assembly.
Assembly will require 2 people.
Step 1: Align Side Panel Legs (B) with the support
rail on the underside of the Desk Top (A).
Place Corner Leg Bracket (E) in holes on
support rail, and insert 10x35mm Screw (G)
through bracket and into legs. Tighten using
Allen Wrench (I).
Step 2: Attach Pedestals (C) to underside of Desk Top (A)
by aligning screw holes in Pedestals with holes in
Desk Top, and inserting 6x55mm Screws (F) to secure.
Tighten using Phillips Head Screw Bit (J) or screwdriver.
Step 3: Attach Pedestals (C) to Side Panel Legs (B) by inserting 6x16mm Screw (H)
through pedestal wall and into legs. Tighten using Phillips Head Screw Bit (J)
or screwdriver.
Step 4: Attach Privacy Panel (D) to Pedestals (C) by inserting 6x16mm Screws (H) through
sides of Pedestals (C) and into side of Privacy Panel (D).
1 2 3 4
C
C C
D
F
B
A A
H H
E
B
G
I
J