OFM T3672MB - Manual

A
Table Top
1 Unit
G
Washer
4 Units
H
Leveling Glides
4 Units
D
Center Support Beam
1 Unit
B
Right/Left Base
2 Sets
C
Cross Support Bar
2 Units
E
Leg Post
2 Units
F
Mesh Sheath
2 Units
K
8x20mm Bolt
4 Units
L
6x15mm Bolt
8 Units
J
Long Bolt
4 Units
I
Table Top Bolt
16 Units
Assembly Notes:
During assembly, hand tighten screws only. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Model T3672MB
Mesh Base Conference Table 36” x 72”
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
03.05.2014
STOP
Assembly Instructions
Tools Needed: (1) Large / (1) Small Allen Wrench (Included)
Please read all instructions before assembly.
Step 1a: Slide Mesh Sheath (F) over Leg Post (E). Set Post (E)
on floor with rim facing up. Insert Right/Left Base (B)
into the bottom of the Leg Post (E). Cover bottom with
Washer (H), and insert Long Bolt (J) through Washer (G)
and into Post (E) and hand tighten.
Step 1b: Screw Leveling Glides (H) into bottom of Base (B).
Step 1c: Attach Cross Support Bars (C) to top of Leg Posts (E)
by inserting 8x20mm Bolt (K) through Bar (C) and Leg
Post (E). Only hand tighten bolts.
Step 2: Using a second person to help, attach Center Support
Beam (D), with open side facing up, by inserting 6x15mm
Bolt (L) through end of Center Support Beam (D) and into
the aligned holes on the Leg Post (E). Repeat for the
second leg. Securely tighten all bolts inserted so far.
Step 3: Attach Table Top (A) by inserting Table Top Bolt (I)
upwards through Cross Support Bar (C) and into the
aligned holes in the Table Top (A). Securely tighten all
Table Top Bolts (I) only when all 16 have been inserted.
1
C
K
F
H
B
J
G
E
2
D
L
E
3
I
C
A
M N
Small Allen Wrench Large Allen Wrench