OFM UT3060 - Manual

I
Phillips Head
Screw Bit
1 Unit
1 2
A
Table Top
1 Unit
G
10x35mm Bolt
4 Units
D
Leg Post
4 Units
B
Short Beam
2 Units
C
Long Beam
2 Units
E
Corner Bracket
4 Units
F
6x16mm Screw
10-12 Units
Assembly Notes:
During assembly, loosely tighten screws. When all screws
are in place, you may then tighten all screws completely.
CAUTION:
1. Do not use this table as a step ladder.
2. Check for loose screws and tighten them every 6 months.
Models UT2448 / UT2460 / UT3048 / UT3060
Utility Tables
Parts Listing
919-362-4765 (fax)
www.ofminc.com
161 Tradition Trail, Holly Springs, NC, 27540
800-520-7471 (voice)
919-303-6389 (voice)
[email protected]
03.11.2014
STOP
Assembly Instructions
Tools Needed: Allen Wrench and Phillips Head Screw Bit
Please read all instructions before assembly.
Step 1: Place Table Top (A) upside down on a clean, flat
surface. Align Leg Posts (D), as shown, to each
corner where the Short Beams (B) and Long Beams (C)
meet. Attach Corner Bracket (E) to one hole in Short
Beam (B) and one hole in Long Beam (C), and insert
10x35mm Bolt (G) through Corner Bracket (E) and into
Leg Posts (D). Tighten using Allen Wrench (H).
Step 2: Align holes in Short Beams (B) with holes on the
underside of the Table Top (A). Insert 6x16mm Screws (F)
through beam and into Table Top (A), and secure using
Phillips Head Screw Bit (I) or screwdriver. Repeat on
other side and with Long Beams (C).
Note: Level table with adjustable leveling glides on bottom of
Leg Posts (D).
D
F F
B
C
H
E
G
A
H
Allen Wrench
1 Unit
A