Canon VB-C10R - Manual (Page 106)

6-2
○ ○ ○ ○ ○ ○
VB-C10R Connection Example
Connector Attached Cable
IN + , IN – Sensors mounted on the door
Using the Still Picture Recording Function Linked to an External Device
Ethernet
Sensor A
VB-C10R
Camera contr
o
l
and video ima
g
es
Sensor B
By combining various sensors and switches to operate according to External Device Input settings,
it is possible to build a monitoring system that responds to external events. Still pictures are
recorded in the VB-C10/VB-C10R’s memory (
→ P.3-16).
Sample Application Combining a Door-opening Sensor
This is a monitoring system in which the VB-C10R installed in the ceiling records pictures every
second for 3 seconds before the doors opens and 7 seconds after the door opens between 5 p.m.
and 6 a.m. The equipment shown in the figure below is connected to the terminals on the rear of
the VB-C10R at installation.
○ ○ ○ ○ ○ ○
Installation Example
When the door opens and sensor B mounted on it separates from sensor A, an ON event occurs
at external device inputs IN + and IN – . In response to this event, the VB-C10R records pictures at
the entrance and stores them.
IN – IN +
Remove some insulation at the end of the cables from the sensor and
insert them into the IN + and IN – terminals on the plug for the external
device. Then tighten the screws on the plug to secure the cables.
Insert this plug with the cable into the external device I/O jack on the rear of the VB-C10R.
Note
Please confirm the Date and Time settings on page 3-10.